Used to break loose old unions and cut out corroded copper or galvanized nipples. A clean cut means a clean solder joint or press fitting on the new line.
Water Heater Installation Schertz TX Done Right the First Time
When your tank starts leaking or your hot water runs out in five minutes, you need water heater installation schertz TX homeowners can count on. We install gas and electric units for homes and businesses across Schertz, Cibolo, and Universal City. Same-day estimates, no surprises.
Serving schertz and nearby areas.
How big is the job?
Size or fuel change
Bigger tank, gas to electric, or new venting and gas line work.
- 1. Simple swap Same size, same fuel, easy access in a garage or open closet.
- 2. Size or fuel change Bigger tank, gas to electric, or new venting and gas line work.
- 3. Tankless or tight access New venting, gas upgrade, or attic and platform work planned first.
Drag the needle to compareTouch and drag the needle
- 28Services from one local team
- 10Areas served around schertz
- Measure twiceWe size by first-hour rating, not guesswork.
- Test every jointPressure gauge and soap test before we leave.
What Our Water Heater Installation Includes
Every install covers the full swap: removal, new unit, code-correct connections, testing, and cleanup.
Work order
Water Heater Installation- Old Tank Removal and Haul-Away: We drain the old tank, disconnect the gas or power, and carry it out. The unit, the pan, the old fittings, and the packaging all go on our truck. You are not left with a 150-pound tank in the garage or a pile of scrap copper on the driveway.
- New Heater Set and Connected: We set the new unit on a level pad inside the pan, connect the water lines with copper pipe or PEX tubing, and install a new flexible gas connector and sediment trap on gas units. Electric units get a dedicated circuit check and new elements torqued to spec.
- Code-Correct Venting and Permits: Gas installs need proper venting, combustion air, and a permit. We pull the permit, build the vent to current code, and coordinate the inspection. If your old flue was undersized or damaged, we replace it instead of reusing it.
- Full Leak and Pressure Test: Every joint gets soap-tested or sniffed with leak detection equipment. We fill the tank, purge the air, and watch a pressure gauge for 15 minutes. Gas joints get a second check after the burner fires. Nothing gets signed off until it holds.
- Walkthrough and Paperwork: We show you the shutoff valve, the temperature setting, and the anode rod location. If anything looks off in the first 30 days, you call us and we come back.
What the first visit covers
First visit
We check the old unit, the venting, the gas or power, and the pan drain, then confirm the flat price.
Water Heater Installation at Homes
We install and swap heaters for houses, duplexes, and rentals across Schertz.
Leaking tank swap
Drain, haul out, set new unit the same day.
Size upgrade
Bigger tank or tankless for a growing family.
Gas to electric
Fuel change with new circuit and capped gas line.
Rental turnover
Fast swap with photos and paperwork for the owner.
Water Heater Installation at Businesses
We install commercial-grade heaters for small businesses that cannot afford downtime.
Restaurants
High-recovery units sized to kitchen demand.
Salons and spas
Heaters that keep up with back-to-back clients.
Small offices
Code-correct installs with minimal disruption.
Water Heater Installation Schertz TX: What the Job Actually Involves
A heater installed right lasts 10 to 15 years and keeps your floors dry. Installed wrong, it leaks, fails inspection, and costs you twice. We do it once, to code.
Water heater installation schertz TX is the full replacement of your tank or tankless unit, from draining the old heater to pressure-testing the new one. We pull the old unit, inspect the pan and drain line, then set the new heater on a level pad. Gas units get a new flexible connector, sediment trap, and Teflon tape on every threaded joint. Electric units get a dedicated circuit check and new elements torqued to spec. Every job ends with a pressure gauge test and a 30-minute heat-up cycle.
Most Schertz homes we service were built between 1995 and 2015, so their original heaters are now 10 to 20 years old and past their rated life. Hard water in this part of Bexar County eats anode rods fast, and a failed rod means rust inside the tank. If you are searching for water heater replacement near me schertz, we can usually get eyes on your unit the same day. We also swap out the shutoff valve and check the expansion tank while we are there.
- What it is
- Full replacement of your tank or tankless water heater.
- When it helps
- Leaks, rusty water, or hot water that runs out fast.
- What you get
- New unit, code-correct hookup, and a leak test.
Our Water Heater Installation Process
Every job follows the same five steps. You will know what is happening, who is doing it, and when the hot water comes back on.
Tools and Methods We Use on Every Install
Each method answers a different question. Together they leave very little to guess.
We solder copper pipe where it makes sense and use a press tool for tight closets where a torch is a bad idea. Both methods meet code and both get pressure-tested.
We watch the gauge for 15 minutes after filling the tank. If it holds, the joints are sound. If it drops, we find the leak before we call the job done.
Gas joints get sniffed and soap-tested after the burner fires. This is how we catch a slow leak at the sediment trap or flexible connector before it becomes a callback.
If the heater pan drain is clogged, the next leak goes into the drywall. We clear the line with a snake or hydro jetter so the pan actually drains outside.
When Schertz Homeowners Call Us for Heater Installation
A 12-year-old tank in a Cibolo garage starts leaving a quarter-sized puddle every morning.
We treat it as a failing tank, not a repair.
HomesA Universal City family of five keeps running out of hot water with a 40-gallon electric tank.
We size the replacement by first-hour rating and recommend a 50-gallon electric unit or a Navien tankless upgrade.
HomesA Schertz rental property has a heater from 2004 and the tenant reports rusty hot water.
We confirm the anode rod is gone, quote a flat install, and coordinate with the property manager.
BusinessesA homeowner in 78132 is selling and the buyer's inspector flags the 14-year-old heater.
We do a same-week install so the sale does not stall.
Homes
How Water Heater Installation Runs in Schertz
Schertz sits on the edge of Bexar County where the water is hard enough to shorten anode rod life by years. Most of the homes we service were built between 1995 and 2015, so their original heaters are now at or past the end of their rated life.
Schertz Heights
Older homes here often have 40-gallon gas tanks in garage closets with undersized venting. We upgrade the flue to current code as part of the install.
Cibolo Crossing area
Newer builds from the 2010s are hitting their first heater replacement now. Most are 50-gallon gas units on a platform in the garage.
Northcliff
Homes here frequently have electric tanks in interior closets with no floor drain. We route the pan drain to a safe spot before setting the new unit.
- Schertz Heights
- Cibolo Crossing area
- Northcliff
- Windcrest and Live Oak border
From problem to finished result.
Slide to compare the photo with an illustrative inspection view. It is generated from the photo, not a measurement.
PhotoLeaking 50-Gallon Tank in Cibolo
Before: A 2009 Rheem tank in a Cibolo garage was leaving a quarter-sized puddle every morning. The anode rod was gone, the pan drain was clogged, and the shutoff valve was frozen open. The homeowner was mopping daily and worried about a full flood.
After: We cleared the pan drain with a drain snake, replaced the shutoff valve, and installed a new 50-gallon Rheem on a fresh pan. The job took 3.5 hours. The floor has been dry for six months and the hot water lasts through four showers.
Tankless Upgrade in Universal City
Before: A family of five in Universal City had a 40-gallon electric tank that ran cold after the third shower. The panel had room for a dedicated circuit but the closet had no venting for a gas unit. They wanted endless hot water without a bigger tank.
After: We installed a Navien tankless unit, ran new stainless venting through the side wall, and upgraded the gas line from the meter. The install took 7 hours. Now all five can shower back-to-back with no temperature drop.
Rental Property Swap in 78154
Before: A property manager had a 2004 AO Smith tank in a Schertz rental with rusty hot water and a tenant threatening to withhold rent. The unit was past its rated life and the permit file was empty. The owner needed documentation for the file.
After: We pulled the permit, installed a new AO Smith unit, and sent the owner photos of the finished work plus the model number and install date. The tenant had clear hot water the same day. No emergency calls since.
Problems We Solve With New Water Heater Installation Schertz TX
Most heater calls start with one of these four problems. Each one has a fix, and most fixes are a same-day install.
Tank is leaking from the bottom
A leaking tank will not stop.
Hot water runs out in five minutes
A tank full of sediment heats slowly and delivers less hot water every month.
Rusty or metallic-tasting hot water
Once the anode rod is gone, the tank itself starts corroding.
Gas smell or yellow flame at the heater
A yellow flame or gas odor means incomplete combustion or a leaking connection.
Why Schertz Homeowners Replace Instead of Repair
A new heater is not just about hot water.
Cut Gas Bills 10-20%
A modern Rheem or Bradford White unit with a 0.62 energy factor uses 10-20% less gas than a 15-year-old tank.
End Rusty Water for Good
Once a tank's anode rod is gone, rust flakes into your supply and stains every load of laundry.
Code-Correct Gas Hookup
Gas water heater installation schertz jobs require a sediment trap, proper venting, and a flexible connector rated for the appliance.
No More Midnight Floods
A 50-gallon tank that lets go dumps 50 gallons across your garage or utility closet.
What you receive on install day
Clear records you can keep and share.
Model and install date
Written on your paperwork for your records.
Permit and inspection file
Copies for gas installs and closing files.
Photo record
Images of the finished install on request.
21 Years Installing Heaters in Bexar County
Pro Plumbing Schertz has been installing water heaters since 2005, which means 21 years of Schertz tanks, Schertz water, and Schertz code.
Data plate
We read the model, size, and fuel type to match the replacement.
Anode rod
We check wear to judge water quality and tank life.
Pan drain
We test flow so the next leak has somewhere to go.
Is your schertz area covered?
Type your ZIP code or town. If you are nearby and not listed, call and ask.
schertz ZIP codes
- 78108
- 78154
- 78132
Towns we serve.
Based in schertz and covering the places around it. Pick one for local details.
What Schertz Customers Say About Our Heater Installs
Our 15-year-old tank started leaking on a Friday night. Pro Plumbing Schertz had a plumber out Saturday morning with a new 50-gallon Rheem on the truck. He drained the old one, set the new one, and had hot water back by lunch. Flat price was exactly what he quoted on the phone. No upsell, no mess left behind.
We switched from a 40-gallon electric tank to a Navien tankless. The crew ran new venting, upgraded the gas line, and walked me through the temperature settings before they left. It took most of the day but they cleaned up everything. Endless hot water for three teenagers is worth every penny.
I manage six rental units in 78154 and Pro Plumbing Schertz has done four heater swaps for me in the last two years. They pull the permit, coordinate the inspection, and send me photos of the finished install. Tenants get hot water the same day. That is why I keep calling them.
Frequently Asked Questions About Water Heater Installation
Short answers for the first few minutes. The team can cover the rest.
Still have a question?
Describe what you are seeing and we will point you to the right next step.
876383746Electric swaps sit at the lower end; gas swaps with new venting sit at the higher end. We give you a flat number before we start.
A standard tank swap takes 2 to 4 hours from arrival to hot water. Tankless installs run 4 to 8 hours because we run new venting and often upgrade the gas line. If your old unit is in a tight attic or a closet with no drain, add an hour for the drain-down and haul-out. We schedule morning starts so you have hot water by evening.
Most Schertz families of four do well with a 50-gallon gas tank or a 40-gallon electric tank. If you have three or more bathrooms or a big soaking tub, step up to a 75-gallon tank or a Navien tankless unit. We size by first-hour rating, not just tank volume, so you do not run cold mid-shower. We will do the math with you on the call.
Yes. Gas water heater installation schertz jobs are a big part of what we do. We install the unit, build a code-correct sediment trap, connect a new flexible gas connector, and test every joint with leak detection equipment. If your venting is undersized or your flue is damaged, we fix that as part of the job. We pull the permit and stand behind the inspection.
Related Services
Other services from the same team.
Get Your Water Heater Installation Schertz TX Quote Today
876383746Call now and we will give you a flat price over the phone, usually in under five minutes.
Contact Pro Plumbing Schertz
Call us at 876383746 for same-day plumbing service in schertz. We answer the phone, not a machine. Most calls placed before noon get a same-day visit.